Alkali and alkaline earth metal anodes are gaining increasing research attention because they could provide high energy densities and theoretical specific capacities. Among them, lithium metal is the most investigated anode candidate for next generation batteries. However, due to some challenges, the commercialization of lithium metal anodes is still delayed. Reactions between lithium metal and the electrolyte lead to the formation of an inhomogeneous solid electrolyte interphase (SEI). Consequently, electrodissolution/-deposition of lithium is favored where the SEI is less resistive or cracked, resulting in high surface area lithium and dendrite growth. This does not only lower the coulombic efficiency (CE) and cell specific capacity but also causes safety issues due to an increased risk of short-circuits and thermal runaway.^1,2 To enable increased safety in high energy batteries with lithium metal anodes an effective SEI is required to limit lithium dendrite growth. There is a variety of approaches to grow an effective SEI, such as the use of electrolyte additives, mechanical methods and chemical modification.^3-5

Recently, alkaline earth metal anodes, such as magnesium or calcium, are also of considerable interest for next generation anodes. Their main advantage is the significantly lower susceptibility to dendrite formation, while still offering high theoretical specific capacities. However, their oxide passivation layer does not allow significant mobility for their divalent ions, leading to large overvoltage and slow reaction kinetics which hinders the cycling. Therefore, electrolytes which enable a non-passivating SEI have to be applied and additives are investigated on their ability to remove the oxide layers.^6,7

Herein, we present a novel mechanochemical approach to form an effective SEI on the lithium metal surface by combining mechanical and chemical modification utilizing ionic liquids (ILs) prior to cell assembly. This method suppresses dendrite growth even at high current densities of 10 mA cm^-2 in lithium metal batteries with liquid electrolytes. To further highlight the importance of surface treatment and SEI formation, we investigate electrolytes for calcium metal batteries as well as mechanical modification of calcium metal anodes.

Acknowledgements:

The authors would like to acknowledge financial support from the European Union through the Horizon 2020 framework program for research and innovation within the project “VIDICAT” (829145).

References:

1. Peled, E.; Menkin, S., Journal of The Electrochemical Society 2017, 164 (7), A1703-A1719.
2. Bieker, G.; Winter, M.; Bieker, P., Physical Chemistry Chemical Physics 2015, 17 (14), 8670-8679.
3. Peled, E., Journal of The Electrochemical Society 1979, 126 (12), 2047-2051.
4. Josef, E.; Yan, Y.; Stan, M. C.; Wellmann, J.; Vizintin, A.; Winter, M.; Johansson, P.; Dominko, R.; Guterman, R., Israel Journal of Chemistry 2019, 59 (9), 832-842.
5. Wellmann, J.; Brinkmann, J.-P.; Wankmiller, B.; Neuhaus, K.; Rodehorst, U.; Hansen, M. R.; Winter, M.; Paillard, E., ACS Applied Matererials & Interfaces 2021, 13 (29), 34227-34237.
6. Shterenberg, I.; Salama, M.; Yoo, H. D.; Gofer, Y.; Park, J.-B.; Sun, Y.-K.; Aurbach, D., Journal of The Electrochemical Society 2015, 162 (13), A7118-A7128.
7. Stievano, L.; de Meatza, I.; Bitenc, J.; Cavallo, C.; Brutti, S.; Navarra, M. A., Journal of Power Sources 2021, 482, 228875.