Platinum (Pt) is a critical element in making electrocatalysts for oxygen reduction reaction (ORR) occurring at the cathode of polymer electrolyte membrane fuel cells (PEMFCs). To address the Pt abundance issue and to enhance Pt catalysis, Pt is often alloyed with another transition metal M (i.e. M = Fe, Co, and Ni). Ordered intermetallic PtM alloys are considered as one of the most promising candidates to achieve both high activity and stability in practical fuel cell applications. The transition metals in ordered intermetallic PtM alloys occupy specific sites, and are stabilized by both metallic and ionic bonding. Ordered intermetallic structures are formed via high temperature (>600 °C) annealing of disordered PtM alloys, as the atomic ordering is a thermodynamically driven process. However, the high temperature annealing inevitably leads to the migration and agglomeration of the nanoparticles forming randomly alloyed particles with poor dispersion and broad size distributions, due to weak adhesions to the carbon support under typical processing conditions. To prevent this coalescence during annealing, protective coating of the nanoparticles with inorganic shells or physical barriers has been suggested. However, these studies were limited to the synthesis of intermetallic nanoparticles on carbon supports at low metal loadings, or require an additional step of removing the coating layer from the surface of the nanoparticles to expose the active sites. Thus, it is essential to develop a general approach that can produce highly dispersed, structurally ordered nanoparticles while achieving controls over the size and size distribution. We propose to use the functionalized carbon supports to control PtM alloy nanoparticle size and prevent nanoparticles from aggregating during the high temperature annealing through improving the metal-support interactions. A strong electrostatic attraction between the negative charge from Pt precursor (PtCl₆^2-) and positive charge from the amino groups (C-NH²⁺) on the surface of the functionalized carbon will be established during the wet impregnation synthesis. Such bonds will help to make the PtM nanoparticle size smaller and more uniformly distributed over the surface of support. The ordered intermetallic 30 wt.% PtCo/KB-NH₂ catalyst demonstrated an average size of 2.7 nm and uniform size distribution. In addition, 30 wt.% PtCo/KB-NH₂ catalyst exhibited a mass activity of 535 A/g_Pt (H₂/O₂) and a rated power density of 1.05 W/cm² at 0.67 V (H₂/air), meeting the DOE targets.