1183
Novel Cathode Materials for Rechargeable Magnesium Ion Batteries

Thursday, 23 June 2016
Riverside Center (Hyatt Regency)
L. Wang and F. Vullum-Bruer (Norwegian University of Science and Technology)
Over the past few years, considerable effort has been devoted to the development of new energy storage devices with high power and energy density to substitute Lithium-based batteries, because the predicted high demand associated with many large-scale applications has generated serious concerns regarding the safety and sustainability of metallic Li.[1] In particular, Mg ion battery (MIB) has been regarded as the most promising candidate because of its ‘green’ character, high natural abundance in the Earth’s crust (13.9% as compared to 7*10-4 % for Li), and chemical stability.[2] In comparison with Li, Mg is inherently much safer due to its stability in air and lack of dendritic formation during electrochemical cycling.[3] Also, compared to Li, Mg has a theoretical volumetric capacity of 3833 mAh cm-3, nearly twice that of Li (2061 mAh cm-3), indicating that MIB has a good potential for reaching a high volumetric energy density.[4,5] However, it is still in high demand to find the electrode materials that unites with metallic Mg and fulfil requirements such as high specific capacity, power density, rate performance and good cyclability.[2,6,7]

Here, we report several novel cathode materials, Mn3O4 nanoparticles, Mn3O4/graphene nanocomposite, Fe3O4 nanoparticles and microwave exfoliated graphite oxide (MEGO). The studies of Mg-battery performances were carried out in a standard coin cell which the synthesized materials as cathode, magnesium ribbon as anode, glass fibre as separator and (PhMgCl)2-AlCl3/THF as electrolyte. The electrochemical performance was evaluated by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and galvanostatic charge-discharge techniques.

References:

[1] L. G. Lu, X. B. Han, J. Q. Li, J. F. Hua and M. G. Ouyang, J. Power Sources, 2013, 226, 272.

[2] E. Levi, Y .Gofer and D. Aurbach, Chem. Mater., 2010, 22, 860.

[3] J. O. Besenhard and M. Winter, ChemPhysChem, 2002, 3, 155.

[4] M. Matsui, J. Power Sources, 2011, 196, 7048.

[5] C. Ling, D. Banerjee and M. Matsui, Electrochim. Acta, 2012, 76, 270.

[6] H. D. Yoo, I. Shterenberg, Y. Gofer, G. Gershinsky, N. Pour and D. Aurbach, Energy Environ. Sci., 2013, 6, 2265.

[7] I. Shterenberg, M. Salama, Y. Gofer, E. Levi and D. Aurbach, MRS Bull., 2014, 39, 453.