Electrochemical Characterization of Sb-Doped SnO2 as Electrocatalyst Support for Electrochemical Energy Conversion Systems

Electrochemical energy conversion systems, mainly Unitized Regenerative Fuel Cells (URFC) and Solid Polymer Electrolyzer (SPE), are considered to have a promising future due to the generation of hydrogen in a clean and sustainable way. However, the design of oxygen electrodes is the main limiting factor for an efficient performance. In this matter, most of the studies have been focused in the development of efficient electrocatalyst for the oxygen reduction and water electrolysis reactions, and the use of electrocatalysts supports different from conventional carbon-based materials, which is susceptible of corrosion at the URFC and SPE operation conditions. Corrosion resistance supports, with improved surface area and conductivity, would reduce the electrocatalyst loading,the membrane electrode assembly degradation rate, and the global construction cost of the systems.  The present work deals with the synthesis and electrochemical characterization of a Sb – doped SnO₂ (ATO) for their potential use as electrocatalyst support in the oxygen electrode in electrochemical energy conversion systems. The synthesis of the support was performed by the sol –gel technique with a surface area modification with dodecylamine as surfactant followed by a thermal treatment. Electrochemical stability was evaluated by cyclic voltammetry (CV) with 250, 400 and 500 cycles in a wide range (0 – 2.0 V vs ENH), while the chronoamperometry (CA) was evaluated at high anodic potential (1.8 V vs ENH) in a continuous period of time of 5 h and 8 h. The results revealed that the Sb doped SnO2 support, present good electrical properties  and electrochemical stability at a higher potential of 1.8 V vs. NHE in the presence of O2, as compared to other carbon-based and commercial sub-stoichiometric titanium oxide (Ebonex ®) supports.