M02 Poster Session

Tuesday, 2 October 2018: 18:00-20:00

Universal Ballroom (Expo Center)

2030

Piezoelectric Micro- and Nanostructured Fibers Fabricated from Thermoplastic Nanocomposites Using a Fiber Drawing Technique: Comparative Study and Potential Applications

X. Lu, H. Qu, and M. Skorobogatiy (Ecole Polytechnique de Montréal)

2031

Copper Electrodeposition from a Deep Eutectic Solvent, Used for Nitrates Reduction

B. M. Teodoncio, M. G. Montes de Oca-Yemha (Universidad Autónoma Metropolitana-Azcapotzalco), J. Aldana-González (UAM), E. M. Estrada-Arce (Instituto Politécnico Nacional, ESIQIE), M. A. Romero-Romo, and M. E. Palomar-Pardavé (Universidad Autónoma Metropolitana-Azcapotzalco)

2032

Mechanical Microsensors for Pulse Measurement

F. Garcia-Castro, O. De Sagazan, C. Simon, N. Coulon, and F. le Bihan (IETR, Univ Rennes1)

2033

3D Printable Soft Conductive Nanocomposites

K. Ahmed, M. Kawakami, A. Khosla, and H. Furukawa (Yamagata University)

2034

Investigation of Printing Properties on Paper Substrate

T. K. Saha, T. N. Knaus (Washington State University), A. Khosla (Yamagata University), and P. K. Sekhar (Washington State University, Vancouver)

2035

Platinum Thin Film TCD Designed for 3 Omega Sensing of Gas Mixtures

A. Lotfi, M. Navaei (Georgia Tech Research Institute), and P. J. Hesketh (Georgia Institute of Technology)

2036

Simultaneous Determination of Young’s Modulus and Residual Stress in PECVD a-SiC from Postbuckling Vibration of MEMS Beams

R. Pratap (Indian Institute of Science) and A. R. Behera (Indian Institute of Science, Bangalore)

See more of: M02: Wearable Sensors and Systems 1 -and- Microfabricated and Nanofabricated Systems for MEMS/NEMS 14
See more of: Sensors

<< Previous Session | Next Session >>