Light Alloys: Corrosion and Protection 1

Monday, 29 May 2017: 08:20-11:40
Grand Salon D - Section 22 (Hilton New Orleans Riverside)
Chairs:
Sannakaisa Virtanen and Yoshinao Hoshi
08:20
Welcoming Remarks
08:30
928
Tailoring the Corrosion Behavior of Biodegradable Mg Alloys By Surface Modification
S. Virtanen (FAU, Institute of Surface Science and Corrosion)
08:50
929
Study of Transport Properties of Polyelectrolyte-Cellulose Acetate Membranes
J. Hakanpää, K. Yliniemi, B. P. Wilson (Aalto University), F. Singer, S. Höhn (Friedrich-Alexander-Universität Erlangen-Nürnberg), E. Kontturi (Aalto University), and S. Virtanen (Friedrich-Alexander-Universität Erlangen-Nürnberg)
09:10
930
Deposition of Ultrathin Cellulose Nanofibers Films As Bio-Implant Corrosion Coatings
B. P. Wilson, N. Paukkonen, K. Yliniemi (Aalto University), M. Hakalahti, T. Tammelin (VTT Technical Research Centre of Finland), E. Kontturi, and M. Lundström (Aalto University)
09:30
Break
10:00
931
10:20
932
Initial Corrosion Study of Magnesium Alloys in Simulated Body Fluid By SECM
E. Mena Morcillo, L. P. Veleva (CINVESTAV, Merida, Applied Physics Department), and D. O. Wipf (Mississippi State University)
11:00
934
Corrosion Resistance of LZ91 Magnesium Alloy with a Permanganate Conversion Coating and Electroless Ni-P Plating
S. Y. Jian, K. L. Chang (National Defense University), J. K. Chang, C. S. Lin (National Taiwan University), and M. D. Ger (National Defense University)
11:20
935
Effect of Isothermal Oxidation and Sol-Gel Thin Film Formation on Corrosion Behaviour of AZ31 and AZ61 Commercial Magnesium Alloys
F. R. García-Galván (Centro Nacional de Investigacones Metalúrgicas (CSIC)), L. Diaz (Centro Nacional de Investigaciones Metalúrgicas, CSIC, Universidad Simon Bolivar, Caracas, Venezuela), A. A. El hadad (Physics Department, Al-Azhar University, Cairo, Egypt, Centro Nacional de Investigaciones Metalúrgicas, CSIC), V. Barranco (Instituto de Ciencia de Materiales de Madrid, CSIC), I. Llorente (Centro Nacional de Investigaciones Metalúrgicas, CSIC), A. Jiménez-Morales (Universidad Carlos III de Madrid), S. Feliu Jr., and J. C. Galvan (Centro Nacional de Investigaciones Metalúrgicas (CSIC))